What are the common problems in the use of vacuum oil filter
2019/4/21??????view:
What are the common problems in the use of vacuum oil filters? Chongqing Zhongjing Filtration Equipment Manufacturing Co., Ltd. will give you an answer. Firstly, vacuum oil filter is a commonly used industrial oil filter equipment, which can quickly remove impurities in various oils, such as engine oil. It has very good effect. It has stable performance, good purification effect and simple operation of the equipment. It can be used in a wide range of mechanical equipment, on-site equipment refueling, on-site vacuum pumping is very convenient, and can be used in power, metallurgy, machinery, transportation, chemical, petrochemical and railway industries, with huge demand.
Secondly, the vacuum oil filter can dynamically treat the oil in the case of non-stop production, reduce the production and operation costs, eliminate waste oil combustion and emissions, and avoid the resulting environmental pollution. At present, there are many types of vacuum oil filters in the market, such as hydraulic oil vacuum filters, turbine oil vacuum filters, transformer oil vacuum filters, two-stage vacuum filters, explosion-proof vacuum oil filters and so on, which play an important role in improving the quality of oil.
What are the common problems in the use of vacuum oil filters?
1.Vacuum does not meet the technical standards.
(1)Water-bearing multi-vacuum pump in filter oil pumps out excessive water vapor. Solution: It belongs to the normal phenomenon and needs to be filtered many times.
(2)Because of the different altitudes of the sites used, the variation of vacuum is not affected by the standard atmospheric pressure. Solution: It is a normal phenomenon to increase the temperature of oil to evaporate water.
(3)In the vacuum pump, the vacuum oil is lower than the oil level line. Solution: Increase vacuum oil.
(4)Vacuum oil, because of its long use time and high water content. Solution: New oil needs to be replaced.
Sealing oil leakage at each joint. Solution: Check and repair.
Vulnerable parts of vacuum pump wear heavily. Solution: Replace fragile parts.
2.Working pressure is too high in normal working conditions.
(1)The filter is blocked. Solution: Clean the filter.
(2)The drainage pipeline is too long, the header gate is too water, and the oil level to the main tank is too high. Solution: Improve working conditions.
3. Reasons for vacuum pump injection.
The water content of the filtered oil is high, and the oil drift rises and is sucked into the vacuum pump and the oil level rises in the vacuum pump. Solution: Replacement of vacuum oil shall not exceed the oil level line.
(2) Shift or damage of sealing gasket in vacuum pump. Solution: overhaul.
4.Oil temperature does not rise after start-up heating or can not be controlled.
It may be that the thermometer is damaged or malfunctioning. Solution: Repair or replace the temperature controller.
(2)The heating pipe is burnt out or broken. Solution: Check and replace heating pipe.
There is no market electricity. Solution: Check and repair.
Vacuum oil filters are used in strict accordance with the operating procedures. When starting the oil filter, the oil can be recycled only after the vacuum pump, oil pump and heater are running normally and the internal circulation is good. In winter operation, insulation measures should be adopted for pipes, vacuum tanks and other components. When oil is filtered in substations, it must also comply with the regulations issued by the power industry. Maintenance should be carried out frequently and minor faults should be found and eliminated in time. If you can't solve the problem, contact the manufacturer as soon as possible!
- Pre：Operation steps of vacuum oil 2019/4/21
- Next：Vacuum oil filter after-sales 2019/4/21